Oct 13, 2010 #1 I Insayne Active Member Joined Oct 5, 2010 Messages 775 Reaction score 0 Got my white face gauges today :headbang: install went pretty good but my tach hangs don't spin smoothly and won't drop below 1000 rpm Without me hitting the dash. What gives?
Got my white face gauges today :headbang: install went pretty good but my tach hangs don't spin smoothly and won't drop below 1000 rpm Without me hitting the dash. What gives?
Oct 13, 2010 #2 JiMi_DRiX Well-Known Member Joined Jan 10, 2010 Messages 1,044 Reaction score 0 Location Tucson, AZ Pull the needle up a little bit, its pushed down too far.
Oct 13, 2010 #3 joekd Well-Known Member Joined Jan 14, 2009 Messages 3,968 Reaction score 129 Location Ct Either the needle is set too low or the dash face isn't fully flat on that one area Sorry but the only way to fix is pull it apart again
Either the needle is set too low or the dash face isn't fully flat on that one area Sorry but the only way to fix is pull it apart again
Oct 13, 2010 #4 OP OP I Insayne Active Member Joined Oct 5, 2010 Messages 775 Reaction score 0 I think it's a combo of both. My coolant gauge isn't registering maybe it's to low?
Oct 14, 2010 #5 ttocs Forum's #1 poster Joined Oct 9, 2009 Messages 37,642 Reaction score 7,761 Location Evansville Indiana the piece you put in is probably just rubbing the needles. Seen too many people mess up their dash with those to ever consider doing it.
the piece you put in is probably just rubbing the needles. Seen too many people mess up their dash with those to ever consider doing it.
Oct 14, 2010 #6 OP OP I Insayne Active Member Joined Oct 5, 2010 Messages 775 Reaction score 0 I just pulled the needles up and it's gravy
