Verifying my cam/head setup

[97stanger]

Well, I'm almost 100% positive I'm going to go with a set of ported and polished PI heads for my new build. I just wanted to make sure this was okay. I already have a set of Crower Stage 2 NON PI cams sitting in my garage. Would it be okay to still use these non pi blower cams in the ported/polished PI heads? Also, as long as the heads are romeo (which my non pi's were), my team breed valve covers should bolt right up right? thanks guys

 

[NERD]

IIRC, crowers are really mellow cams and are about the equivalent to Comp 262h's and will work fine. No where near peak of what you could gain with specific application cams.

 

[97stanger]

I think these specific crower ones I have were about max of what I could put in my non pi heads. I was told these were the abosolute non pi blower cams available on the market, before they discontinued them

252 Lobe 256 Adv Duration
266 Valve 270


204 Lobe 208 Duration at .050
220 Valve 224


.532 / .532 Gross Lift

 

[97stanger]

bump