AaRoN
King Post Whore
Since my car is gonna be hibernating in the garage for the next few months thanks to winter :nonono: I decided I'd start doing some of the little things that I've wanted to do and maybe do alittle experimenting.
I really want to straighten out the engine bay cause it's so messy. And it's been that way since the motor swap. I just haven't had anytime to mess with it; but because of the snow I have a few months to get it done ;D I haven't actually started the engine bay yet but here's what it looks like right now. Ideas and input are greatly appreciated O0
ENGINE BAY
FRONT OF BAY:
PASS. SIDE OF BAY:
DRIVER'S SIDE OF BAY:
TAILLIGHT BEZELS:
3 NUTS TO GET THESE TAILLIGHTS FREE AND READY TO REMOVE
THEY JUST PULL STRAIGHT OUT
THE BEZEL WAS A PITA TO SEPERATE (3 SCREWS & 3 TABS TO PRESS DOWN)
INTERIOR TOUCHES (some which has been done for awhile)
PEDALS PADS, VENT, TRIM UNDER STEERING WHEEL
RUNNING HORSE DECAL, DOOR HANDLE BEZEL
GT EMBLEM (WHICH YOU CAN'T SEE REAL WELL BECAUSE OF THE FLASH)
VENT, GLOVE BOX
CENTER CONSOLE LID
DOES ANYONE HAVE INPUT ON HOW TO MAKE THIS STAND OUT?
I really want to straighten out the engine bay cause it's so messy. And it's been that way since the motor swap. I just haven't had anytime to mess with it; but because of the snow I have a few months to get it done ;D I haven't actually started the engine bay yet but here's what it looks like right now. Ideas and input are greatly appreciated O0
ENGINE BAY
FRONT OF BAY:
PASS. SIDE OF BAY:
DRIVER'S SIDE OF BAY:
TAILLIGHT BEZELS:
3 NUTS TO GET THESE TAILLIGHTS FREE AND READY TO REMOVE
THEY JUST PULL STRAIGHT OUT
THE BEZEL WAS A PITA TO SEPERATE (3 SCREWS & 3 TABS TO PRESS DOWN)
INTERIOR TOUCHES (some which has been done for awhile)
PEDALS PADS, VENT, TRIM UNDER STEERING WHEEL
RUNNING HORSE DECAL, DOOR HANDLE BEZEL
GT EMBLEM (WHICH YOU CAN'T SEE REAL WELL BECAUSE OF THE FLASH)
VENT, GLOVE BOX
CENTER CONSOLE LID
DOES ANYONE HAVE INPUT ON HOW TO MAKE THIS STAND OUT?