Although this is my first post, I have been doing A LOT of reading on here. Thanks to all the people that took the time and effort to put out information!
So the question is this:
I am ready to start adding horsepower and eventually run twin turbos (ON3):
Where is the logical place to start?
If I'm going to do a full PI swap, should I just pull the whole engine (185,000ish miles {odometer stopped at 150,000}) and have the machine shop go over it?
Should I buy ebay PI heads, should they be pressure checked before install?
The fuel pump is currently dead and I was going to replace it with the Walbro 255LPH. Thoughts?
ANY suggestions are welcome, thanks in advance!
So the question is this:
I am ready to start adding horsepower and eventually run twin turbos (ON3):
Where is the logical place to start?
If I'm going to do a full PI swap, should I just pull the whole engine (185,000ish miles {odometer stopped at 150,000}) and have the machine shop go over it?
Should I buy ebay PI heads, should they be pressure checked before install?
The fuel pump is currently dead and I was going to replace it with the Walbro 255LPH. Thoughts?
ANY suggestions are welcome, thanks in advance!