'97 Cobra roller - caged - $2,000 OBO

dino · Feb 8, 2011

trying this again, mostly for the hell of it. don't need to sell, just will be a while before i get time to truly devote to this car.

'97 Cobra
Pacific Green w/ tan interior.
car had a lil over 100k miles, but cluster was replaced when car was built and now shows 274.

bad: driver's door needs work/replaced. it opened while backing up and grabbed a pole at loooow speeds, the front edge is pretty mussed up. i have a straight black door i'll include. 2 dents on passenger quarter from a mid-pipe falling on it.

needs: longblock, trans, cooling system, front brakes, underhood a/c(if desired).

good:
8-pt JBZ-fab'd rollbar, very well built.
through-the-floor subframes w/ seat braces
torque box reinforcements
UPR anti-roll bar on chassis. will need new tabs welded on rear end to complete.
will come with 99-04 3:73 GT rear(can arrange stock mach rear if so desired) with eibach sportline springs
03 cobra a-arms, H&R race springs, KYB AGX struts up front.
fuel system is in place, along with wiring. engine harness has been modded for the use of four MSD coils, will work with any version 4v heads. everything behind dash is left intact(all a/c, heat, etc is all there.) only things missing from interior are seats and a radio.
will come with silver 98 cobra wheels with good 275/40's all around.
hood has hood pins installed.

$2,000 OBO for the roller.

i can include some extra parts for it if so desired. (these prices only good with roller, please do not ask about parts only. as of now, they are only for sale to buyer of roller)
t-45, rebuilt with very low miles. - 350
tri-ax shifter for t-45 above - 50
BBK LT's and o/r H. LT's have some rash on bottom, but very usable. - 250
01 cobra upper and lower intake and throttle body - 200
'03 cobra heads and mach valve covers - 750

take it all for 3,300.