I've had the light since the rebuild was finish a couple months go.I've tried jumpering out the connector to get the code(s) but the light never flashes.....?
Could be the same problem as mine, ABS computer is kaput. You'd need a code reader that will read ABS codes to be sure. I still need to replace mine at some point..
Been a while, but i finally tried a new ABS computer and it solved my problem.......for a while.......now the light comes on intermittently.I jumped the test connector out and got a code 33 which says "Left front ABS sensor continuity fault".I ohmed the sensor out and got 1100ohms which according to my sources ,is in spec....?......any ideas?
Check the wiring for stripped insulation where it could ground out. It sounds like there is a part of the wire that is stripped and will move around causing it to ground out intermittently.
Check the wiring for stripped insulation where it could ground out. It sounds like there is a part of the wire that is stripped and will move around causing it to ground out intermittently.