So I took my car in this weekend to get an alignment and had an issue. When i got my car the PO had installed some granatelli CC Plates, but I'm not sure if he didn't install them straight or what's up. They were able to get the passenger side really close on the camber, but they had the driver side maxed out and the camber was still off by a decent amount. They didn't charge me for the alignment since they couldn't get it right. They said they could install some new plates if I brought them in.
Any guesses on what might cause it to be off?
If it's a hole drilled wrong is there another brand J&M, MM, etc. that could get put in even though there's already a hole in there?
I saw the QA1's on AM and those appear to be direct bolt in so I figure those could probably work. Is there something else that might cause the camber to be way off?
Any guesses on what might cause it to be off?
If it's a hole drilled wrong is there another brand J&M, MM, etc. that could get put in even though there's already a hole in there?
I saw the QA1's on AM and those appear to be direct bolt in so I figure those could probably work. Is there something else that might cause the camber to be way off?