couple pics, installed the MM plates

[Steven]

Installed my MM plates, still need to get it aligned but I figured i'd take a couple pics.

not bad for a faded pink laser red ol mustang

 

[lrall]

have you tried gettin a cutting pad and PC and tryin to 'bring her back? Ive seen it done

 

[Steven]

have you tried gettin a cutting pad and PC and tryin to 'bring her back? Ive seen it done

na to be quite honest i'd have to pay somebody who's a pro at it to do it.. I have neither the patience nor the experience to really make it right.

 

[AaRoN]

looking good! O0

 

[Red96GT]

have you tried gettin a cutting pad and PC and tryin to 'bring her back? Ive seen it done

That's a little faded, you can't bring it back.

Did you do the caster/camber plate install yourself? It must be the angle but it doesn't look like the strut shaft will clear the hood. :dunno:

 

[SRT Handz]

that paint can be brought back......i used to think i couldnt detail now look at what i can do. ;D Just go out, Buy a PC and try some Buffin'

 

[Steven]

have you tried gettin a cutting pad and PC and tryin to 'bring her back? Ive seen it done

That's a little faded, you can't bring it back.

Did you do the caster/camber plate install yourself? It must be the angle but it doesn't look like the strut shaft will clear the hood. :dunno:

Yep, Not hard at all. MM gives you options on setting the suspension up and i choose to do it that way to allow for more travel. The strut clears fine mainly because the hood I bought is more "oriented" for extreme camber/caster and all types of setups. Clears fine, the hood is molded in with cut outs > Yea I might go after it. What do yall suggest to save the paint?

 

[Lightning Struck]

that engine bay pic, the elbow at the TB looks smaller than what it is say around the mass air ???

 

[94darkhorse]

that paint can be brought back......i used to think i couldnt detail now look at what i can do. ;D Just go out, Buy a PC and try some Buffin'

Exactly it won't be that hard. Just get a pc and a cutting pad with some form of cutting compound, then a good paint cleaner and glaze should finish it off.

 

[dutman98]

3m makes some nice rubbing compounds. I would go with some perfect it 3 for the cutting and finish it off with a black waffle pad and some swirl remover.

 

[Steven]

that engine bay pic, the elbow at the TB looks smaller than what it is say around the mass air ???

:dunno:

 

[SRT Handz]

is that a painted Ebay CAI?

 

[Steven]

is that a painted Ebay CAI?

yep.. it surprisingly matched the red sorta.. it was like 50 bucks and i was annoyed with the stock crap plastic

 

[eliyarbrough]

Faded-smaded! If you want faded, look @ mine!! Looks good I think!!