Grommet alternatives?

[Daryl]

I managed to lose or misplace the grommet on the CAI tube that holds the air sensor in place. The new sensor is threaded but I can’t find a threaded grommet that will fit it.
1. Does anyone know where I could get a replacement grommet?
2. If the grommet is not threaded (which is like it won’t be), can I safely secure the sensor into the grommet using some kind of adhesive?

And lastly:
3. can anyone recommend a spark plug wire set with the correct number of angled boots so I don’t fry my wires again?
4. I’ve been running FP the MSD 8.5mm. Would 8mm wires work the same? Better? Worse? No difference?

Thanks!!

 

[ttocs]

Not sure what to say about the grommet. Worst case scenario use some sillycone?

your not going to gain hp on the wires, but you will save $$$

 

[Daryl]

Not sure what to say about the grommet. Worst case scenario use some sillycone?

your not going to gain hp on the wires, but you will save $$$

So 8mm wires will do the same as 8.5mm? And yes, I know, wires don’t add hp. 8mm sets just more available

 

[RAU03MACH]

Grainger for the grommets
for the spark plug boots { heat wrap }

 

[RAU03MACH]

 

[RAU03MACH]

granger has many sizes

 

[Daryl]

Awesome, thanks John!

 

[96blak54]

Silicone on a clean surface, maybe ruffed up a bit with scotchbrite too, is a seriously good glue. If you find something that'll work, maybe the silicone to help it stay put.