96blackstang
New Member
- Joined
- May 25, 2007
- Messages
- 22
- Reaction score
- 0
We first tested the cobra seat to check which motor controlled the same adjustments. We clipped the connector of the V-6 Seat and we cut the connector off the cobra seat for just the up, down, back and forth adjustment. Then we connected the connector from the V-6 seat to the cobra seat by stripping the wires back, soldering it on and using heat shrink on it for a good connection. Then we mated the seat connector to the wire harness on the car and it worked.
We still have to run power to the other motor that controls the side bolsters and lumbar, I just have been working so much and since its my daily driver, we havent had time to do it.
Now Im kicking my self cause I should have done a step by step write up on it...I never thought anyone else would want to go thru the trouble of doing that, and we had been drinking while we did it...LOL
We still have to run power to the other motor that controls the side bolsters and lumbar, I just have been working so much and since its my daily driver, we havent had time to do it.
Now Im kicking my self cause I should have done a step by step write up on it...I never thought anyone else would want to go thru the trouble of doing that, and we had been drinking while we did it...LOL