Powerdyne Supercharger

[Import Slayer95]

What's up? I just picked up a powerdyne supercharger for my 95 GT for cheap. It came with a 6lb pulley and a 9lb. and wanted to know if anybody was running the same thing and what they thought of it???? My next questions are what all do I have to buy because it didn't come with any timing retards and was unsure what lb. injectors to use. Also do I need to change out fuel pumps or will the stock do just fine. Thanks for reading!

 

[foss_94gt]

Get a 255 intake fuel pump, 42 pound injectors, get a lightning maf/ or other brand maf and get a tune, and have fun

 

[slopony]

Get a 255 intake fuel pump, 42 pound injectors, get a lightning maf/ or other brand maf and get a tune, and have fun

yep ^ the powerdyne's in stock configureration are a little light in the boost department. when I had the 3.03 pully(6psi) it made about 4-5 psi. I went to the 2.93(9 psi) and it made about 6-7 psi. I would also run a bypass valve to help in compressor surge. I had a bypass set up on mine with the super powerdyne rebuild from 928 motorsports and it was bad ass. the upgrade really helped out a ton.

 

[mikey94gt]

I helped install one on a 94 Cobra, it put down 358 after the blower, just adding the blower, 36# injectors, 255 pump and chip. this was on the 6psi pulley at sea level.

 

[Import Slayer95]

bout how much was that rebuild from 928?

 

[Import Slayer95]

Does the powerdyne supercharger for the fox body 5.0's fit the 95' 5.0's?

 

[justinschmidt1]

you probably would need a bracket for a 94/95 but the actual blower should work

 

[Import Slayer95]

do you have one??

 

[slopony]

bout how much was that rebuild from 928?

the super powerdyne reuild was $1300, race rebuild is $700 but doesn't come with impeller or shaft, standard rebuild is $325

Does the powerdyne supercharger for the fox body 5.0's fit the 95' 5.0's?

head unit yes but you have to reclock the discharge of the volute

do you have one??

Yes, I have a extra 94-95 bracket for a powerdyne that my buddy made on his cnc machine out 3/8 steel. it's a little thicker and heavier than the aluminum one that comes in the kit.

 

[Import Slayer95]

how much do you want for it? and would the pullies from the 5.0 fox work on a 95' 5.0?

 

[slopony]

not sure about the pullies. i haven't seen the fox set up but I would think the crank pulley at least work. you would still have to come up with the spacers and the triangle bracket that bolts up to the head.