Right Now

jys97cobra · Nov 30, 2007

juss installed front pads and rotors and now looking at the clutch fork and cable. got a roughness in the pedal, i wanna lube inside the tranny where can i lube on the fork or throw out bearing?

uncltrvlnmatt · Nov 30, 2007

You are not going to unless you pull the trans.

Slow95Cobra · Dec 1, 2007

dont spray anything into the bellhousing. all that mess will get on the clutch, then its done for. only lube that can be done, is pull the trans, put a light coat of bearing grease on the input shaft.. anything else i would say is not needed

jys97cobra · Dec 1, 2007

I got some on there with the tranny in hahahahaha...jk. pressed the clutch and held it with a prybar, put a acid bruich on a long screwdriver and bent it. used antiseize to lube the retainer where it slides on. feels smooth now. very nice

uncltrvlnmatt · Dec 1, 2007

jys97cobra said:
I got some on there with the tranny in hahahahaha...jk. pressed the clutch and held it with a prybar, put a acid bruich on a long screwdriver and bent it. used antiseize to lube the retainer where it slides on. feels smooth now. very nice

Anti-seize is not a good lubricant. Depending on the type you get it has alluminum (silver in color) or copper (gold in color) filings in it.