trickflow spacer

[blacknotch302]

like the title says im needing a trickflow 1' spacer for my 95 gt i have one ordered but there on back order and im needing one now would prefer the spacer somewhat new and with all the hardware thx guys

 

[miss2slocoupe]

you have to have 100 post to sell an item... sorry. it just helps us get to know you and weed out scammers. stick around though

 

[blacknotch302]

sorry didnt mean to put it in this section meant to put it in the wtb section thx for the heads up!

 

[miss2slocoupe]

sorry didnt mean to put it in this section meant to put it in the wtb section thx for the heads up!

ohh ok then LOL im sure it doesnt go against buying

 

[lilj4u2njoy]

Where did you order it from? There are tons out there... I got mine from summit, arrived the next day

Sent from my PG86100 using Tapatalk

 

[blacknotch302]

i ordered mine from latemodel restoration and i went on summit and it said it would ship may 21 2012

 

[ttocs]

prettysure 1/2" is the biggest spacer you can run with the stock hood. Hope you have a cowl hood already.

 

[Steven]

Moved the thread. Good luck on the hunt

 

[det_riot]

give steve@cjpp a pm!

 

[lilj4u2njoy]

prettysure 1/2" is the biggest spacer you can run with the stock hood. Hope you have a cowl hood already.

Not exactly, I ran my stock hood for several months with a one inch spacer, BUT I had to cut the liner out and then with a dremel cut The middle brace out and shave the hood down in the center very thin, just enough to get by lol... Much easier to get a cowl hood tho lol but there are ways to keep the stock hood if ud like

Sent from my PG86100 using Tapatalk

 

[ttocs]

yea a 1/2" would have been ALOT easier too.....

 

[lilj4u2njoy]

yea a 1/2" would have been ALOT easier too.....

This is also true

 

[blacknotch302]

i have a cobra r hood just needing the spacer haha