1994 Cobra Vortech V3-Si Build

[KidK9]

Well I finally started to build by supercharger. Tonight I ordered 39# FRPP injectors, Walbro 255 fuel pump, and MSD 6AL-2. Next comes the Anderson Power Pipe and then the polished Vortech Unit. Based on my signature, anyone wanna guess, what the dyno numbers will read??

 

[justinschmidt1]

1,275 rwhp....
you probably should include a boost figure if you plan on getting remotely accurate guesses.

If your running a stock 3.6 pulley I would say probably not much, maybe 320 rwhp?

 

[KidK9]

A guy over on stangnet put up 396rwhp on a completely stop engine with an extremely conservative tune...

 

[KidK9]

10-12lbs boost.

 

[justinschmidt1]

A guy over on stangnet put up 396rwhp on a completely stop engine with an extremely conservative tune...

on how much boost?....that sounds like a really, really, high reading dyno consdering a stock 5.0 might dyno what 180-200 rwhp?...that would mean that 5.0 should need around 16-17 psi to double its output+ like that.

Dont get too caught up in dyno numbers.

10-12lbs boost.

With that kind of boost I would think you should 350-370 rwhp I guess?

 

[itsblue95]

how much does your setup make right now without the blower?

 

[justinschmidt1]

Thats also a very important question.

Consider this, whatever power your motor makes now, it would take roughly 15 PSI to double its output.

 

[Mrstangerbanger]

I used the UPR boost pipe and it worked perfect. Also with 10 to 12 psi you should see 350 rwhp that's 400 crank hp

sent from custom Samsung tap running ICS