Here's the dilemma. I don't have access to the lifts atwork at the moment, and I’m wondering if any of you have managed to snake yourtail pipes in on jack stands, and if so, how'd you do it. I’ve alreadyinstalled the new h pipe, and half of the cat back.
94 GT Tailpipe Install
- Thread starter Awtblo
- Start date
Pushrodsnake
New Member
Place your jack stands underneath the rear frame rails (just ahead of the forward lower control arm mount) and let the rear end hang.
Musturd
Post Whore
- Joined
- Feb 12, 2011
- Messages
- 11,223
- Reaction score
- 3,672
Oh it's a motherbiitch
belber095
Legend
i took mine out with the help of a friend.. it was really annoying, but it came out after a while
OnyxCobra
Post Whore
yeah like pushrod said letting the rear axle hang is key. I've been known to support the rear diff, unbolt the shocks and then let the axle down even further for more clearance.
Steve-Oh
Legend
Remove axle. Makes it real easy.
Sent from Space
Sent from Space
Musturd
Post Whore
- Joined
- Feb 12, 2011
- Messages
- 11,223
- Reaction score
- 3,672
How do they look ? No not the tail pipes the rockers ? I'm kinda lost on why you would jack it up there ...
They look fine, it didn't do anything to them, it's the same spot we use to lift em on the lift. I did it so the axle could hang. On pts, ford lists it as a jack point.
LOl make sure there made for your car. I brought some that was for some other mustang or something and we had to cut and weld shit to get them on . It was a *****. My whole bassani catback is cut custom rofl from the mufflers to tail pipe section.
