Disable low oil sensor?

[bumblebee]

I have an aftermarket oilpan on my car...

So now I dont have any place to put my Low Oil Sensor, how should I do so the light in the dash doesn't comes on?

I know the easy way is to remove the bulb but thats seems not to be the right way...

 

[modo]

its a ground switch. just disconnect the harness from the sensor and it will stay off

 

[Suspect]

yea just take the sensor off the wire then zip tie wire somewhere. ez.

 

[bumblebee]

Oh good!

This is the oilpan I have, still waiting for it tough...
http://www.summitracing.com/parts/MOR-20506/?rtype=7

what do you think?

 

[mikey94gt]

If its anything like my Moroso oil pan, the drivers side corner will interfere with the clutch cable, if you have a 5spd. It will bend the end of the cable bad enough that it will break the cable. i ended up putting a huge nut around the cable, and it still wants to cut the clutch cable. Ill see if I can get pix later, if you like. it looks like you have the same style kick out though.

 

[bumblebee]

If its anything like my Moroso oil pan, the drivers side corner will interfere with the clutch cable, if you have a 5spd. It will bend the end of the cable bad enough that it will break the cable. i ended up putting a huge nut around the cable, and it still wants to cut the clutch cable. Ill see if I can get pix later, if you like. it looks like you have the same style kick out though.

Yes please post pix about the issue...
I have a different bellhousing then original because I'm going to run with a TKO gearbox but maybe it still interfere?

 

[mikey94gt]

If the place where your clutch cable goes is farther out from crank centerline, then it may work. I have a feeling the Moroso oil pans were created for the automatic equipped drag strip cars.