Ninety8stang
Well-Known Member
So I have a Dorman remanufactured PI intake and i know the castings are different on the dorman but my question is on a good set up how much power can this intake be costing me as opposed to the FRPP/OEM?
Dorman intake Vs. FRPP/OEM PI intake?
- Thread starter Ninety8stang
- Start date
Orange Stang
Well-Known Member
- Joined
- Jul 11, 2009
- Messages
- 1,656
- Reaction score
- 2
arent runners on the dorman PI intake basically like the NPI ones? Ive seen the two side by side and i was like wholy FUbar BAtmaN!
Orange Stang
Well-Known Member
- Joined
- Jul 11, 2009
- Messages
- 1,656
- Reaction score
- 2
The dorman intakes runners are shorter compared to the FRPP piece IIRC
duff daddy
Legend
There are dyne sheets on the net w side by side and I think it was 10th or so that was lost w the doorman. On the I phone so I'll ck later on the pc
OP
OP
Ninety8stang
Well-Known Member
thanks duffman. yeah when i look at this intake it has very similar attributes to a nPI intake but has the PI ports. i noticed where on an OEM part it has a cylinder type deal that runs through the middle of the dome to guide airflow where as the dorman just has a hump in the center leaving the air to scatter then shoot toward the intake runners. IDK what the hell but it isnt right. Hhahah
