Hooking up a window switch 96' 4.6

[95_BOSS]

I posted this already in the 96-98 tech but havn't had much luck there. So since this is based on nitrous, I'll give this forum a try.

On a 96' 4.6, where is the best place in the engine bay to get the RPM signal for the window switch? I was wondering if splicing
into one of the wires going to either of the coil packs would work.

 

[blown98gt]

I am like 99% sure i used one of the clip splicers and spliced onto my coil pack.

what unit do you have and are you trying to install?

 

[95_BOSS]

I am like 99% sure i used one of the clip splicers and spliced onto my coil pack.

what unit do you have and are you trying to install?

It is a full zex kit

 

[blown98gt]

just follow the instructions that Zex has..

 

[95_BOSS]

I've already looked at the instructions that come with the switch on the internet....they are not car specific. It just tells you to run
the green wire to an RPM signal.

 

[Willis_98GT]

orange/white wire behind passenger side kick panel, or off your dist..