HP/TQ estimate?

[MrNiceGuy]

What would you estimate a motor with these mods would put out


Romeo Block .20 over
Ported PI heads
VT stage 2 cams
80mm Plenum and throttle body
85mm MAF
CAI
FRPP under drive pulleys
X-pipe with flomasters (no cats)



anyone with similar mods? or does anyone have an idea of what kinda power it will put out?

 

[Lightning Struck]

around 350fwhp would be my guess, do you have all these parts now?

 

[Jrgunn5150]

310.

 

[Lightning Struck]

310.

RW or FW?? Im sure you mean rear wheel, hes go PORTED PI heads and stage 2 cams

 

[nesqwick_05]

290rwhp would be my guess.

 

[Jrgunn5150]

Rwhp. I used to have a pretty similar combo/

 

[Lightning Struck]

Rwhp. I used to have a pretty similar combo/

O0

 

[Mr Jones 4.6]

I need to get me some P&P heads...lol 310rwhp if its a 5-speed sounds reasonable.

 

[Lightning Struck]

I need to get me some P&P heads...lol 310rwhp if its a 5-speed sounds reasonable.

Yep I would say so, I would also suggest Longtubes / 24lb injectors / and a dyno tune that comes to mind right away

 

[Mr. OAM]

With the stated mods....

285 RWHP
270 RWTQ

............completely a guestimation.


Steve

 

[Dalamar]

300-350 HP neighborhood. just where it ends up depends on the tune.

 

[Jrgunn5150]

I'm curious how benficial the .020 overbore is, mine was just on a PI swap. So I had 10.3:1 compression, but stock bore.

 

[Dalamar]

very minimal. the bore is just to clean up the walls for the new pistons/rings. - if you didn't know that already.

 

[Jrgunn5150]

That's what I suspect, but I want to see if the "unshroading" of the veles will actually take place.

 

[Dalamar]

Pretty sure it takes more diameter than that.
the whole sleaved out setup.

 

[Jrgunn5150]

I agree, someone else is on the counter side of this arguement, lol.

 

[MrNiceGuy]

yea i was going to try and start getting it together this weekend but since my rear end is mush now i gotta get some gears first :rant:


but yea thats exactly how it will be set up.. and the motor isnt expensive at all :dancing6: i cant wait till we get the motor together and it goes in though