options for the intake tube

[Steven]

Well on the 95 the whole airbox assembly is gone, so i just stabbed a IAT and a MAF into the tube with a ragged rapped around the extra in order to seal it up good. And now i need to see what my options are on doing something about it. For those unaware, its the inlet tubing setup, aka cold air, air box, whichever. Any ideas? No C&L, to expensive. Cheapest CAI you can find is fine with me. Cheapest I've found is on american muscle for 70 bucks, anyone else know of a cheapy or have something laying around to get it right?

 

[AaRoN]

PVC pipe or you can go to a hardware store and put together some dryer vent piping.

 

[Steven]

thought about that, however i do like a little bit of bling with my whip :coolsmiley:

 

[AaRoN]

thought about that, however i do like a little bit of bling with my whip :coolsmiley:

Rattle can it or get it powder coated.

 

[stang94X]

get the cheap $30 ones off of ebay

 

[Steven]

they look like its just a turn after the maf, not the tube that goes from the TB to the maf

 

[ScottyDsntKnow]

Cheap exhaust piping, weld it yourself, grind down the welds and paint it. Or just get one of the cheapo ebay ones, they really aren't as bad as ppl say. They might not fit PERFECT but that's what hammers and grinders are for!