p0340

[Wayne]

ok this is odd because the mill light is off the scanner says that it is suppose to be off yet I get this code not as a pending code but as a code any Ideas yes it is the cam position sensor code but why is the mill light not triggered to be on?

 

[duff daddy]

that means its a stored fault if its in there and not active at this time

 

[Wayne]

ok I guess when the rain lets up I'll start checking the wiring could be something there.

 

[Wayne]

Ok checed the wiring noticed a white frost looke on the pens coming out of the sensor so i scratched them clean with a pen knife and sprayed them with electrical cleaner so far no code.

 

[duff daddy]

yea that was prob it. just get some dielectric grease and lube it up and see how it goes

 

[Wayne]

for some reason it didnt want to crank real easy the other day "Just the one time that just never happend before" but I put the scan tool on it today and still no codes ran good all day. I did put some fuel injector cleaner in it and Its about time for the fuel filter to be changed but I will get around to it after I do some other work to it.