qa1 front end help

[Ineedav8]

Found a good deal deal on a qa1 front end problem is its for a 5.0 fox im just spit ballin but has anyone got away with fitting a 5.4 4 valve mod motor on a qa1 fox 5.0 front end in a snive its only $50 out of pocket so i figured its to good to pass up and any heads up on there products? Sorry for the stupid question's

:angry7:

 

[white95]

I have a QA1 k-member (stock coils/a-arms) but have plans for a MM kmember with coil overs and their tubular a-arms. I have no complaints about the QA1 piece, I just wanna upgrade to the MM unit because its more suited for my plans of open track racing.

You would have to fabricate new mounting plates to accommodate the big mod motor. You would be better off with a 4.6/5.4 specific k-member.

 

[Musturd]

Yea you can get a mod motor k member for cheap

 

[D3VST8R96GT]

One of the magazines there a gt500 motor in a fox ... just use a modular k member (they used spacers to drop the motor down a bit)

The D3V

 

[Ineedav8]

Figured as much just ask to see if it was entirely stupid

 

[chrisv_10]

If you or you know someone good at fabrication. I would buy it and weld modular specific motor mounts.