Teardown has continued

voidfinger · Feb 16, 2008

Used it on a set of cobra pistons ... and i think they are cast aluminum... didn't mess them up.. just cleaned the hell outa them lol.... maybe if you let it set or something.

Jrgunn5150 · Feb 17, 2008

:dunno: it's what I always used until I got my part's washer.

humjaba · Feb 19, 2008

Got them both off and cleaned them up a bit with some carb cleaner and some shop towels. Need to keep going though.

humjaba · Feb 19, 2008

Oh, and I forgot to mention, my friend decided he would try getting some gunk off with some 200 grit sand paper. He only got a couple strokes in before :tickedoff:
It left marks. Not by any of the ports, but still, they're there. Should I just get them resurfaced?