trans swap

rz5.0 · Jan 20, 2011

i just wrecked my 95gt. i found a replacement but its an auto(not purchased yet). so if i was to put my t5 in it what would i have to swap over. computer,trans, flywheel, clutch, some wiring not sure what yet? anything else how hard is it.

LAFENATU · Jan 20, 2011

iirc..

T5 or Tremec

Bellhousing

Shifter

Shifter Ball

Flywheel

Flywheel Bolts

Clutch Kit

Clutch Fork

Clutch Cable/Quadrant

Lower Shifter boot

Uppser Shifter boot and bezel

Clutch/Brake Pedal Assy

PCM

Tranny Wiring Harness

Dust Plate

Driveshaft

Tranny fluid

rz5.0 · Jan 20, 2011

would i have to pull the dash to get the pedal assy out.

LAFENATU · Jan 20, 2011

rz5.0 said:
would i have to pull the dash to get the pedal assy out.

Nope, works the same way as a fox mustang. :thumbsup:

Mika · Jan 20, 2011

The std has an added piece to the transmission hump in the floor so you might have to cut out the floor some. There must have some clearance issues for the std as opposed to the auto. i went to auto from std and it caused some fitment problems with finishing the interior but you shouldn't have these problems with your swap.

rz5.0 · Jan 20, 2011

on fox there is a diffrence in wiring to the pcm in autos and 5 speed car. is there any diffrence on sn95 or is the pcm plug and play. would i just be able to beat it with a hammer for clearance or do i have to cut.

Mika · Jan 21, 2011

I'm not sure beating it will work, but you could consider using what you need from the wrecked car. Take a look at it when you start taking it apart. I'm not sure about the wiring I haven't gotten to that part of my build yet.