trans swap

[rz5.0]

i just wrecked my 95gt. i found a replacement but its an auto(not purchased yet). so if i was to put my t5 in it what would i have to swap over. computer,trans, flywheel, clutch, some wiring not sure what yet? anything else how hard is it.

 

[LAFENATU]

iirc..

T5 or Tremec

Bellhousing

Shifter

Shifter Ball

Flywheel

Flywheel Bolts

Clutch Kit

Clutch Fork

Clutch Cable/Quadrant

Lower Shifter boot

Uppser Shifter boot and bezel

Clutch/Brake Pedal Assy

PCM

Tranny Wiring Harness

Dust Plate

Driveshaft

Tranny fluid

 

[rz5.0]

would i have to pull the dash to get the pedal assy out.

 

[LAFENATU]

would i have to pull the dash to get the pedal assy out.

Nope, works the same way as a fox mustang. :thumbsup:

 

[Mika]

The std has an added piece to the transmission hump in the floor so you might have to cut out the floor some. There must have some clearance issues for the std as opposed to the auto. i went to auto from std and it caused some fitment problems with finishing the interior but you shouldn't have these problems with your swap.

 

[rz5.0]

on fox there is a diffrence in wiring to the pcm in autos and 5 speed car. is there any diffrence on sn95 or is the pcm plug and play. would i just be able to beat it with a hammer for clearance or do i have to cut.

 

[Mika]

I'm not sure beating it will work, but you could consider using what you need from the wrecked car. Take a look at it when you start taking it apart. I'm not sure about the wiring I haven't gotten to that part of my build yet.

 

[rz5.0]

every thing is getting swaped over. not sure im going to pick up the auto. im trying to find a 5 speed.