Slykin
Well-Known Member
Ok guys, so I got a bit of a problem. I went to replace a rear axle seal this weekend, thought "hey, this shouldn't be too hard". Well, I didn't do my research and I thought to get my C-Clip out it would help to remove my spider gears. This was all fine too until I tried putting them back in. What happened was that when I was trying to turn the spider gears back into the differential, the round little slide bushing popped off the spider gear when it made contact with the differential case and flew back behind the pinion gear into one of the oil passages. At this point I don't really know what to do. I can't reach back far enough with my hand or a magnet to pull it out. I guess the real question here is do I need to just take it a shop and have them remove everything out of the rear end to reach it or is it possible to pull out the differential without messing up backlash etc? I'd rather not take it to a shop, but if I do I guess it's a good time to put in some 3:55's.. Sorry for the lengthy description. Thanks for any input.
-Travis
-Travis