Seriously? Theres hardly any slack on the wiring harness as it is, and it seems the bunch of wires goes to the right side and the left side..and its connected to the injectors and stuff..how am I supposed to seperate that from the corresponding harnesses?
Fan light on..?
- Thread starter Tbuck07
- Start date
AaRoN
King Post Whore
I hope you can understand these alright:
I also didnt see anything about this in the pi swap write up, just said switch old sensors onto new stuff..Like I said I only switched one sensor, and I believe it was the one that didnt have to be tapped..the one of the left side of intake, looking at it from the front..
AaRoN
King Post Whore
FYI: when you look at a motor for reference to left and right, you always look at it from the book. Manuals use this method.
Ok. But looking from the back of the motor then, the left sensor was already in the intake, and we put the right side one in from the old intake..Do I need to grab my old sensor and put it where I had to tap for the sensor on the PI intake? So confuzzled..
