red95r
Active Member
Alright I'm looking for some wisdom. :angel4:
I'm about to replace the motor mounts on my car, and I would like to know if there's some tips and tricks to the job. I have a 2ton engine lift and a regular car jack, which would be better to use? If I use the engine lift what would be safe for me to hook it onto? The passenger side looks harder to do then the driver-side, but both look cramped and hard to get to. I did read the Haynes manual on this job but it was sort of vague.
I have only replaced the mounts in the jeep and it's a I6 so it was easy. :tongue3:
I'm about to replace the motor mounts on my car, and I would like to know if there's some tips and tricks to the job. I have a 2ton engine lift and a regular car jack, which would be better to use? If I use the engine lift what would be safe for me to hook it onto? The passenger side looks harder to do then the driver-side, but both look cramped and hard to get to. I did read the Haynes manual on this job but it was sort of vague.
I have only replaced the mounts in the jeep and it's a I6 so it was easy. :tongue3:
