New Toy

chaz · Oct 4, 2010

2003 5.4L cobra

Picked it up last week

Motors built to handle 1500hp-

-Al Pipito racing 5.4L .020 over cast iron block(swapped and installed)

-Forged pistons (Manley)

-" rods (Manley)

-" crank (forged)

-cold air, custom tunnel

-Sullivan upper and lower intake manifold

-aeromotive fuel rails

-BBK h-pipe catless

-Magnaflow catback

-kennebell boost-a-pump fuel system

Drivetrain:

-Spec stage 3+ clutch w/firewall adj.

-alluminum flywheel

-26 spline input shaft

-level 5 axleshafts with version 2 hubs

-Detroit tru-trac

-mgw shortthrow

-mgw 6spd knob

Suspension:

-MM caster/camber plates

-MM IRS Delrin Alluminum and polyurithane bushings kit

-mm coilovers (f/r) with 350lb springs

Brakes:

-hawk pads

-stainless brakelines

-4 piston cobra r brembo brakes front

-front kmember and A arms...qa1 setup

Car makes 369hp N/A

For Xmas it will be getting a single or twin turbo set up with a 12lb and 18-20lb tune

mikey94gt · Oct 4, 2010

Damn dood, thats sick!

JonBeast · Oct 4, 2010

Wow thats a serious cobra...put the cobra wheels back on, the FRs look tiny.

bottlefed97 · Oct 4, 2010

Lookin good! I like your plans for it.

got5.0 · Oct 4, 2010

I'm confused... why is it N/A right now? are you just building it for the turbo?

chaz · Oct 4, 2010

Its built for a turbo,

Hence -Sullivan upper and lower intake manifold

US Soldier(stang 98) · Oct 4, 2010

thats tits bro.

CompOrangeSN95 · Oct 4, 2010

soldier took the words out of my fingers... that is absolutely tits man, but I have to admit I like the cobra wheels more

white98stang · Oct 4, 2010

Its time for some prostars now!!!

Sinned83 · Oct 4, 2010

Bad @ss cobra

chaz · Oct 4, 2010

Cobra wheels had some scuffs so I put my wheels from my other car on until I can get a nice set or get them re-coated. I'm sure I want to go with a 10.5 in the rear so I can keep a 315 DR on the rear.