New trans selector

[Bitza]

Decided I would try out a new look for my trans selector.
Machined up at work from a piece of aircraft grade aluminium. Also cut 2 inches out of the shaft and inner rod.
It looks a bit large, but its only 2 inch dia and 2.5 long.
Will be anodized black in the future so it doesnt stick out as much.
Cheers

Chris

 

[lutter94]

pretty cool, did you paint the gear indicator red?

 

[Bitza]

Yep. I used a sharp knife to scrape the orange and white off and painted it with Tamiya clear red. I'm trying a blue led in there for illumination as well.

 

[PinkieT]

Nice! The factory setup is BORING! I found an aftermarket knob and slipped a manual trans boot over the lever on my wife's car. Looks a heck of a lot better.

 

[ttocs]

very cool but I vote to polish the center.

 

[dwcopple]

Nice! The factory setup is BORING! I found an aftermarket knob and slipped a manual trans boot over the lever on my wife's car. Looks a heck of a lot better.

need pic

 

[PinkieT]

need pic

[URL]https://www.sn95forums.com/threads/updating-auto-shifter-on-the-cheap.75026/#post-1447858[/URL]

 

[dwcopple]

Where'd you source the boot from?

 

[PinkieT]

eBay. Just wrapped the bottom around the factory shifter base and used the factory bezel to hold it down.