Runner length ?

[spdtrip]

Does anyone know the runner length on the Edelbrock performer rpm 2 manifold ?
Im trying to compare it with the Trickflow track heat.

 

[spdtrip]

so nobody knows? ok what about compare the 2 manifolds whats better?

 

[auto_x5.0]

Depends on what heads you have, I've learned that much. Some intakes go better with some heads where other will mess up your combo(if that made any sense)

 

[LAFENATU]

What is the combo you have/planning?

 

[Paul]

so nobody knows?

Because it probably doesn't matter. An inch or two of runner length isn't going to be the make-it-or-break-it factor of which manifold performs better.

ok what about compare the 2 manifolds whats better?

Just compare the operating ranges and cross-section sizes of the runner, the intended application, and pick the one better suited to your motor.

Paul.

 

[spdtrip]

I have the Trickflow stage 1 kit, and one of my reasons for wanting another intake is for more mph out of 4th
gear. right now I have 3.73 gears im switching to 4.10's pretty sure im only going to see about 112mph
in 4th @ 6,000 I want to see 116-118 (for future power adder) do you guys think the better intake and maybe
better cam will make it happen? Im in the prosses of talking to Ed Curtis from FTI about this but Im looking for more
opinions from neutral people.thanks,Mark.

 

[Paul]

The cam is more critical than the intake. I'd just do what Ed says, most of the folks here would likely be speculating.

 

[LAFENATU]

Yeah I agree completely.

I would listen to Ed Curtis, the man knows his sh1t when it comes to small block fords.