driveshaft
- Thread starter R94
- Start date
ttocs
Post Whore
I had an aftermarket aluminum shaft already when I put in my t56 magnum. I measured how much I needed to take off of it and then took it to a local driveshaft shop that took care of it. I think it was only $75-100. The guys at silver sport transmission is who I would call myself. That is who I got the magnum from and they seemed to have all the answers to the questions I asked.
cobrajeff96
Well-Known Member
D&D Performance.
Huh… that’s where my TKX is from. I’ll give them a call. Considering an aluminum driveshaft. ;-)
ttocs
Post Whore
They were super nice guys and never needed to search for an answer when I asked, they always seemed to know the answer already.
On it! Leaving them a message in 3, 2, 1…. LOL
ON EDIT: message left (after hours); awaiting call back!
Last edited:
garrittpwl
Active Member
what was their answer? Im in this same process but I was under the assumption my stock driveshaft would work
TKX’s bell housing is shorter by 1”-1.5”, so requires a custom-built driveshaft. Just under $800 from SS. I have a call in to a local driveline shop that’s done work for me in the past. Will check back Monday/Tuesday….
