Think it's worth the time and effort to polish the vortech head unit?
If you dont mind doing it again when it needs it then i would say yes. Itll definitely compliment a shaved, freshly painted bay!
Think it's worth the time and effort to polish the vortech head unit?
Those are the airbag sensors that sits behind the bumper.
Subscribed! Is your exterior paint "KM" "Moonlight Blue"?
I like those covers, good job. Are you going to weld in some scott rod panels when the engine comes out?
Also, does anyone have a good suggestion to where I could get all of my gaskets/seals/pullies? I want good quality or OEM gaskets and seals for the PI engine, as well as new pullies for the timing cover
Felpro works fine. Luckily our engines used the rubber type seals which is much better than the paper cork gaskets. If you have any questions on your wire tuck let me know. Its one of those things where you can kind of decide how you want to run stuff as you go. I've done two wires tucks, 1 on my 95gt and 1 on my 98 and both I did a little differently. Also those valve covers are looking good!
I think I ordered my entire engine gasket set from rock auto.
Nice. Thanks man. Ill look into rock auto. Did you get fel-pro stuff from there?
And I'm done with the passenger side wire tuck, and I've got everything on the drivers side out of the engine bay, but I still have to mount the fuse box and run all the wires. I still need to get a battery relocation too
Question...Whats the best way to remove the harmonic balancer on the PI engine thats not in the car? Breaker bar turns the engine and my impact wouldnt budge it. The only thing I know to do is try a stronger impact gun??
2 bolts in the back of the crank where the flywheel goes, put a pry bar between the two bolts and hold the crank while you break the balancer bolt loose.