What Did You Do To Your Car Today?

Burninriverdiver · Nov 13, 2016

Nothing exciting to view but exciting for me to improve my lousy ride quality.... Replaced stock (156k mile) shocks,struts and inner/outer tie rod ends with new motorcraft parts. This should take care of the steering wheel play (inner tie-rod ends were loose enough to shake by hand)

RedTwilight · Dec 4, 2016

Swapped the drag wheel and Tire setup out with the street setup on the notch now that the race season is over.

[/URL][/IMG]

nitroram33 · Dec 4, 2016

CRAZYHORSES · Dec 4, 2016

I got rid of the stock oil dip stick tube that wouldn't fit with my headers and never read correct anyway. I replaced it with a Lokar dipstick that is way nicer

Firefighter181 · Dec 4, 2016

What is the part number on the dipstick from Lokar if you don't mind me asking? I have to do the same thing this winter.

CRAZYHORSES · Dec 4, 2016

Firefighter181 said:
What is the part number on the dipstick from Lokar if you don't mind me asking? I have to do the same thing this winter.

Lokar ED-5004. Found a dealer on eBay for $49. The old one pulled out fairly easy from under the car and the Lokar I installed by pushing and turning a bit from the top-side. I oiled up the base and O-rings before installation.

Firefighter181 · Dec 4, 2016

Cool, thanks for the info! Mine is out for a re-build so should be a pain free install.

CRAZYHORSES · Dec 4, 2016

Firefighter181 said:
Cool, thanks for the info! Mine is out for a re-build so should be a pain free install.

Oh yeah you got it made then

Burninriverdiver · Dec 6, 2016

Home made COP harness works, just trying to get rid of as much clutter as possible

96blak54 · Dec 6, 2016

Uh.....tech write?

Nice work! Now hows about a tech write up on that!

Burninriverdiver · Dec 7, 2016

96blak54 said:
Uh.....tech write?

Nice work! Now hows about a tech write up on that!

Thanks man! I actually used the write up on this site for the COP harness, it was spelled out in an easy step by step guide. I used the site below (second time around) to have closer to exact measurements on wire length to make it cleaner/ use thicker gauge wires.

http://www.crownvic.net/drock96marquis/COPconv.htm

wmfateam · Dec 9, 2016

Went to install this little thing before dinner and was shot down by the update. Tomorrow I guess.

Sent from my XT1254 using Tapatalk

ttocs · Dec 10, 2016

I laid in the hospital dreaming of wiring my holley system. Got the relay box and wired it up. Got the fuse box and drew up a schematic for all the wiring. And then laid here....

But wish me luck they are going to a follow through test in the morning and maybe a test will show something someday.....