have you considered maybe removing the annodization around the outside of the petal? It would be as simple as some masking tape and either sand paper or oven cleaner to just wipe it off.
Front or rear of car
You made changes to the drive shaft or is it new
Pinon angel for sure
Ok that dual USB port is a cool idea! I just have the second cable lying under the pass seat. Might have to look into something like this to plug into the Holley. I eventually want to add the bigger dash also so that would work well.I’m really excited for this addition to the car. I’ve never liked wires hanging out of the dash for the laptop, so I opted for this “Dual USB 2.0 Data Bulkhead Adapter” from Billet Automotive Buttons. They offered custom engraving as an option and the results speak for themselves. Those guys have a lot of other really cool bits and you should check them out.
View attachment 9014
Realizing I had no where to put this, I decided to approach John @ John Smith Racing to custom 3D print a two gauge panel with provision for my bulkhead panel. He certainly didn’t disappoint and the final product is exactly what I had hoped for. Don’t hesitate to contact him for your own hair brained ideas, I think he likes the challenge!
View attachment 9015
View attachment 9016
View attachment 9017
Nice progress, hopefully the vibration issue is an easy fix
It seems like could be an easy fix but we shall find out. Measured the pinion angle and found the pinion to be 2* lower than the reading taken at the balancer. I have a few shims to install but need a day off.
I really enjoyed that about my job at intel.You need to work half a year like me lol